What should I pay attention to when I buy automatic painting equipment? Recently, I went to inspect a foreign-funded enterprise. The company is very large. The products made by the enterprise are currently relatively good. It is a US-funded enterprise. Their company mainly produces lighting accessories. Coating machine, I went to see the equipment. First of all, we don’t care whether he can make products or not. From the beginning of his process, I feel that entering the workshop is messy, and people are walking around with carts. I will say whether you make products. The yield rate is low, he asked me how do you know, first of all, there is a big problem in designing the equipment from the structural point of view, why do you need to do the turnover instead of using the automatic conveyor line turnover, roll out the full workshop and run around, and how can you ensure that there are so many people The workshop is clean and hygienic. Secondly, we need to know the product process and process. When purchasing equipment, I give some advice to large companies. It is best to call front-line employees to determine the equipment technology and surrounding environment. After all, they are the end users, so they know Those aspects that need to be paid attention to the most. If you don’t pay attention to some subtle technologies, it will affect the performance of the equipment and production. Often the senior management of the company thinks that there are engineers who are very professional in the process and technology. many different? Therefore, some large enterprises buy automatic spraying production lines and go back as a decoration to look good. Either they cannot be used, or they are not ideal for use. They did not design the production line according to the process, resulting in many problems in the details of the equipment. If the product is unqualified or the product yield is very low, large enterprises should purchase automatic spraying equipment and build new automatic spraying production lines mainly as follows:

1. To avoid static sparks, all airless spray equipment should be well grounded.

2. The sprayed paint should be filtered first, and the filter should be selected according to the viscosity and particle size of the paint. Note that the filter is too fine to pass through, and if it is too thick, the spraying is easy to block.

3. The diameter of the outlet pipe and the intake pipe should be in accordance with the specification in order to maintain sufficient air intake.

4. The compressed air from the air pressure enters the spraying equipment after being filtered, which is beneficial to prolong the service life.

5. The capacity of the equipped air compressor should conform to the air consumption of the machine specified in the manual, and should be larger than the consumption if possible.

6. In order to reduce the possibility of pollution caused by the compressor, the air compressor should be kept away from the spraying site as far as possible.

A set of automatic spraying equipment is very expensive, but we bought it to make money for us, not to display it for people to see. Some small companies bought it not only useless but also increased the load, because they I understand very well, so they must pay attention to the above things when purchasing an automatic spraying production line. Maybe their engineers will leave after saying that, which may cause the equipment to be idle, or the equipment sprayed out of the product is unqualified, so here I again advise large enterprises to purchase When the automatic spraying production line is installed, the front-line employees must be required to participate in the requirements.